Paint Chip or Wear Mark Repair

Some 2016-2018 Camaro models may show a paint chip (Fig. 10) or wear mark (marring) (Fig. 11) on one or both of the rocker panel moldings. The chipping or marring may occur when the door makes contact with the rocker molding during an over-slam door closure. The door does not contact the molding once the door is closed. The tight door hem sealer to rocker molding clearance is by design. Adjusting the door will not resolve the wear or mark condition.

Fig. 10

Fig. 11

Do not replace the rocker panel molding or adjust the door if this condition is found. Complete a partial paint repair to the rocker molding to correct the paint chip or wear mark.

Refer to the latest revision of the GM Approved Refinish Materials book to identify the paint system to use to meet GM standards. The GM Approved Refinish Materials book is available within the Unit Repair Manual/Specialty Publication section of the Service Information as well as on the Genuine GM Parts website at www.genuinegmparts.com.

Once the paint repair is completed, install an approximately 1-inch (2.5 cm) piece of Mylar tape to the repair area. Carefully cut the tape to cover the repaired area. (Fig. 12)

Fig. 12

– Thanks to Ann Briedis

Possible Misfire Condition with DTCs Set
Excessive Steering Play, Lash, and/or Steering Gear Leak Conditions

Comments are closed.